Publicidad
Idiomas disponibles
Idiomas disponibles
2610067262 GDR GDS GDX18V-1860C 07-21.qxp_GDR GDX 7/16/21 7:30 PM Page 17
Intended use
This tool is intended for the fastening
and loosening of bolts, nuts and various
threaded fasteners.
Variable speed controlled trigger
switch
Your tool is equipped with a variable
speed trigger switch. The tool can be
turned "ON" or "OFF" by squeezing or
releasing the trigger. The speed can be
adjusted from the minimum to maximum
nameplate RPM by the pressure you
apply to the trigger.
pressure to increase the speed and
release pressure to decrease speed
(Fig. ß1).
Preselecting the speed/impact
rate
Maximum speed can be restricted by
selecting a predefined speed setting of 1
or 2. In each speed range, the variable
speed trigger will still control from 0 rpm
up to the restricted max speed. (See
table on page 9 for more information.)
With the button (9) you can preselect
the required speed/impact rate in three
stages. Press the button (9) repeatedly
until the desired setting appears in the
speed indicator (6). The selected setting
will be saved.
The required speed/impact rate depends
on the material and the working
conditions, and can be determined
through practical testing.
Brake
When the trigger switch is released it
activates the brake to stop the chuck
quickly. This is especially useful in the
repetitive driving and removal of screws.
Operating Instructions
Forward/reversing lever and
trigger lock
position to help prevent accidental
starts and accidental discharge.
Your tool is equipped with a forward/
reversing lever and trigger lock (3)
located above the trigger (Fig. 10). This
lever was designed for changing rotation
of the bit, and for locking the trigger in
an "OFF" position.
To lock the trigger, move the lever to the
center.
Apply more
For forward rotation, (with chuck
pointed away from you) move the lever
to the far left.
For reverse rotation move the lever to
the far right. To activate trigger lock
move lever to the center off position.
until the tool comes to a complete stop.
Shifting during rotation of the chuck can
cause damage to the tool.
Fig. 10
3
17
After tool use, lock
trigger
in
"OFF"
Do
not
change
direction of rotation
3
Publicidad
