Replace Battery - Trust AYCT-303 Manual Del Usuario

EN
AYCT-303 REMOTE CONTROL
Buttons
ON- Button - To turn your lights/devices ON
OFF-Button - To turn your lights/devices OFF
Channels/Group Channel - Connect a receiver to 1 of the 4
channels. Use the group channel to turn multiple receivers
ON or OFF. Note: You cannot dim with the group channel
Dimming - Brightness Increase: Press and hold a channel's
ON button to increase the lamp's brightness
Brightness Decrease: Press and hold a channel's OFF
button to decrease the lamp brightness
1. Remove battery strip
A
Open the battery compartment by inserting a flat head
screwdriver into the slot on the back.
B
Slide the battery compartment open
C
Remove the battery strip
2. Pair remote with receiver
A
Put the receiver into learning mode (refer to the
receiver manual for information on how to activate the
learning mode).
B
Press the ON button of the desired channel to which
the receiver must be paired.
Tip: You can also pair multiple receivers to one channel
3. Removing the back plate for mounting
Remove the back plate from the wall bracket by inserting
a flat head screwdriver into the recess on the bottom and
lifting it up.
6
4. Mounting the wall bracket with screws
A
Place the backplate on a flat surface and mount the
plate securely with the included screws.
B
Place the wall holder on the back plate.
C
Place the remote control in the wall holder.
5. Mounting the wall holder with double-sided
tape
To mount the backplate using the supplied double-sided
tape, apply the tape to the back of the back plate.
Then stick the wall holder on a flat surface at the desired
location.
Unpair a Trust Smart Home receiver
A
Put the receiver you want to unpair into learning mode
(refer to the manual of the receiver for information on
how to activate the learning mode).
B
Press the OFF button of the channel to which the
receiver is paired.

Replace battery

A
Open the battery compartment by inserting a flat head
screwdriver into the slot on the back.
B
Slide open the battery compartment and remove the
empty battery. Insert a new 3V-CR2032 lithium battery
into the battery compartment. Pay attention to the
positive and negative polarity.
Close the battery compartment.