Care And Maintenance - Twin Star DFH-TH-17-TO Manual De Instrucciones

Safety Protection Systems
This product has protection safeguards that shut off the product when parts become
excessively hot. If the product shuts off, immediately turn the Control to the "OFF"
position and unplug it from the electric outlet.
If overheated:
a. Remove any objects near the product that may cause overheating. Use the product
in a well-ventilated area. Keep at least 3 feet (0.9 meters) of space on all sides
of the product to allow adequate air circulation.
b. Allow the product to cool down for at least 10 minutes before plugging it back into
an electric outlet for re-use.
TIP: Always install and maintain at least one smoke detector in good operating
condition on each floor of your home. Periodically check and/or replace the battery in
your smoke detector with a new battery.

CARE AND MAINTENANCE

WARNING: Do not attempt to disassemble this product for any reason, as incorrect
re-assembly could cause a risk of fire or electric shock. Only qualified service personnel
should perform any servicing.
WARNING: Always unplug the product from the electrical outlet and allow it to cool
before cleaning or storing it.
NOTICE: This product is permanently lubricated at the factory before shipping and will
not require further lubrication for the life of the product.
Clean only the exterior surface by wiping with a soft, damp cloth, and allow the product
to dry completely before storing or using. Dust can be removed from any vents using a
small vacuum.
WARNING: Do not allow water or other liquids to enter the interior of the product.
NOTICE: Do not use abrasive cleaners/pads to clean the product.
To store, wind and secure the power cord using a twist tie or rubber band, and then
place the product in a cool, dry location.
E-6