Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO USE YOUR CLEANING SYSTEM
If you have any problems operating your pressure washer,
please call the pressure washer helpline at 1-800-222-3136.
Pressure Washer Location
Pressure Washer Clearance
WARNING
Exhaust heat/gases can ignite combustibles,
structures or damage fuel tank causing a fire.
• Keep at least 5 ft. (152 cm) clearance on all sides of pressure
washer including overhead.
Place pressure washer outdoors in an area that will not
accumulate deadly exhaust gas. DO NOT place pressure
washer where exhaust gas (A) could accumulate and enter
inside or be drawn into a potentially occupied building.
Ensure exhaust gas is kept away from any windows, doors,
ventilation intakes, or other openings that can allow exhaust
gas to collect in a confined area. Prevailing winds and air
currents should be taken into consideration when positioning
pressure washer.
WARNING
Running engine gives off carbon monoxide, an
odorless, colorless, poison gas.
Breathing carbon monoxide can cause headache,
fatigue, dizziness, vomiting, confusion, seizures,
nausea, fainting or death.
• Operate pressure washer ONLY outdoors.
• Keep exhaust gas from entering a confined area through
windows, doors, ventilation intakes, or other openings.
• DO NOT start or run engine indoors or in an enclosed area,
even if windows and doors are open.
All manuals and user guides at all-guides.com
OPERATION
To Start Your Cleaning System
To start your engine-powered cleaning system for the first
time, follow these instructions step-by-step. This information
also applies whenever you start the engine after you have let
the pressure washer sit idle for at least a day.
1. Place pressure washer near an outside water source
2. Check that high pressure hose is tightly connected to
3. Make sure unit is in a level position.
4. Connect garden hose to water inlet on pressure washer
5. Turn ON water, point gun in a safe direction and squeeze
DO NOT run the pump without the water supply connected
and turned on.
• Damage to equipment resulting from failure to follow this
6. Attach PrecisionSpray™ Selector to spray gun according
7. Engage trigger lock (A) to spray gun trigger.
8. Move throttle lever (A) to "Fast" position, shown here as
9. Move choke lever (B) to "Choke" position.
NOTE: For a warm engine, be sure the choke lever is in the
"Run" position.
IMPORTANT: Before starting the pressure washer, be sure
you are wearing adequate safety goggles.
A
• Always wear safety goggles when using this equipment or in
• Before starting the pressure washer, be sure you are wearing
• NEVER substitute safety glasses for safety goggles.
10
capable of supplying water at a flow rate greater than
3.5 gallons per minute and no less than 20 PSI at
pressure washer end of garden hose.
spray gun and pump. See Assemby for illustrations.
pump.
trigger to purge pump system of air and impurities.
NOTICE
instruction will void warranty.
to PrecisionSpray™ Selector instruction sheet.
a rabbit.
A
B
WARNING
Risk of eye injury.
Spray can splash back or propel objects.
vicinity of where equipment is in use.
adequate safety goggles.
A
Publicidad
