General operating conditions
1. The ResistTel MB weatherproof phone can be connected to the
telephone lines of analogue exchanges.
2. The handset is fitted with a stray field coil for connecting hearing aid
devices. Persons wearing a hearing aid device with an inductive
receiver can directly receive the signal of the earphone.
3. The optional external speaker can be used in ringer, open listening
and hands-free modes. The volume of the internal speaker is
reduced when the external speaker is turned on.
4. The phone has a receiver mount with a reed contact hook switch.
The handset must be placed back on the mount to end the call. A
conversation is ended and a new call is started by pressing the
disconnect button on the keypad (see page 8).
5. If the you do not make a selection within 2 minutes, the exchange
can cut off the power supply. Then you will stop hearing the dial
tone. In this case, please place back the handset, wait for 2 seconds
and lift the handset again.
6. An acknowledgement tone confirms that the settings have been
stored.
7. When you receive a call, the ResistTel MB phone rings with the
selected volume.
8. Changing the settings can be prevented by setting a PIN number.
Forgetting the PIN number is similar to losing a key. If you forgot the
PIN number, please contact our technical support service.
9. There is a warranty period of 36 months from the date of purchase.
In case of any problems please contact our technical support
service in Germany, Mülheim an der Ruhr
Phone: 0208 82 68 256 · Fax: 0208 82 68 286
E-mail: fhf-support@eaton.com
Please use the country code if calling from outside Germany:
Phone: +49 208 82 68 256 · Fax: +49 208 82 68 286
4