Publicidad
Idiomas disponibles
Idiomas disponibles
EN
2: Insert the pizza stone.
3: Connection regulator and hose to pizza oven.
Please note the factory setting that the regulator and hose had been assembled to
the pizza oven.
4: Connecting to gas tank.
WARNING:
• Please always keep the gas bottle in upright
position.
• If the appliance is not in use, the gas must be
turned OFF at the supply cylinder.
• The cylinder used must include a collar to
protect the cylinder valve.
• The minimum distance for the appliance and
the gas tank is 1m apart.
15
IMPORTANTE
Read the following instructions carefully and be sure your gas pizza oven is properly
installed, assembled and cared for. Failure to follow these instructions may result in
serious bodily injury and/or property damage.
If you have any questions concerning assembly or operation, consult your dealer or
LPG Gas Company.
When used on the ground always place the appliance and cylinder on flat level
ground.
Your gas pizza oven can be used with gas cylinders between 11 kg and 15 kg. The
maximum size of the gas cylinder should be: Dia. 320mm, Height: 600 mm. Follow
the technical information as stated in the instruction manual and Check with your
local gas supplier to have a suitable gas cylinder for your pizza.
NOTE FOR CONSUMER: Retain for future Reference
CONNECTING THE GAS CYLINDER TO THE APPLIANCE
This appliance is only suitable for use with low-pressure butane or propane gas or LPG
mixtures, fitted with the appropriate low-pressure regulator via a flexible hose.
The hose should be secured to the regulator and the appliance with hose clips. Make
sure the flexible hose could not come in contact with hot surface and avoid twisting.
Use a suitable regulator that is certified to BSEN 12864 or EN 16129. Make sure the
regulator and flexible hose comply with local code.
Please consult your LPG dealer for information regarding a suitable regulator for the
gas cylinder.
Regulator and Hose
Use only regulators and hose approved for LP Gas at the above pressures. The life
expectancy of the regulator is estimated as 2 years.
The use of the wrong regulator or hose is unsafe; always check that you have the
correct items before operating the appliance.
The hose used must conform to the relevant standard for the country of use. Worn or
damaged hose must be replaced. Ensure that the hose is not obstructed, kinked, or in
contact with any part of the appliance other than at its connection.
For Flexible hose
Avoid twisting the flexible tube when the appliance is in use. The length of flexible
hose shall not exceed 1.5m. In Finland, the length shall not exceed 1.2m. The hose
should certified according to applicable EN Standard and comply with local code.
16
EN
Publicidad
