Troubleshooting - TECshow BEAMER Manual De Usuario

Troubleshooting

Problem
No response from fixture
when power is applies
Fixture resets but does
not respond correctly
to controller(DMX mode
operation)
Colors cannot be mixed
Fixture does not reset
correctly
No light, lamp cuts out
intermittently, or burns
out too quickly
Reference
• Control menu
• DMX Channel
• Specification
BEAMER
ENGLISH VERSION
Probable cause(s)
No power to fixture
Primary fuse blown
Secondary fuse blown
Controller not connected
Incorrect addressing of the fixtures
Bad data link connection
Conflict between tracking and vector control
Data link not terminated
Defective fixture or 2 devices transmitting on link
Random color mixing is on
Electronic or mechanical failure
Lamp missing or blown
Fixture or lamp is too hot
Remedy
Check power cables
Replace fuse
Replace fuse
Connect controller
Check address setting on fixture and controller
Inspect cables and correct poor connections
and/or broken cables.
Eliminate scene cross-fade on controller
Insert termination plug in output of last fixture
Bypass fixtures one at a time until normal oper-
ation is regained: unplug both connectors and
connect them directly together
Turn off random color mixing
Contact service technician
Disconnect fixture and replace lamp
Allow fixture to cool. If problem persists, contact
service technician
p. 5