How To; Get Started; Switch On Each Day; Switch On The Image Server - Nikon Optos Monaco P200TE Guia Del Usuario

3

How to...

Before using the system and capturing images, you should be familiar with all the features and capabilities of
the system.

3.1 Get started

CAUTION
Your device should be left in standby mode at the end of each working day.
Note
The device automatically logs out when the device is

3.1.1 Switch on each day

The image server and scan head must be switched

3.1.1.1 Switch on the image server

The review, admin and storage services run on the image server. You do
as the server only needs to be switched on.
Your image server may also be used as a browser-based review client.
1. Check that the power supply is switched on.
2. Switch on the image server.
Note
If it seems the image server is not working, check the monitor is switched on then confirm the image server is
switched on.

3.1.1.2 Switch on the scan head

CAUTION
The scan head should be left in standby mode at the end of each working day and so will need to be started
each day.
1. Remove the scan head fabric cover.
2. Check the image server is switched
Part Number: G108707/8GCA
Copyright 2018, Optos plc. All rights reserved.
Read the warnings and cautions before using your device.
Only use the fabric cover when the scan head is powered
Remove the fabric cover before operating the scan head.
The scan head will move when the alignment system is being centered. This will happen
automatically when the device is switched
centered between patient sessions. You should ensure that there is space around the
scan head to allow free movement.
in use.
NOT
each day for the device to operate.
ON
and when the alignment system is re-
ON
and fully started up before switching
ON
Chapter 3 - How to...
need to login to the image server
NOT
or in standby mode.
OFF
the scan head.
ON
Page 29 of 76
English