Operating The Keys; Switching On The Hob And Cooking Zones; Switching Off A Cooking Zone - FRECAN FLOW 53 Manual De Instalación Y De Usuario

Operation

5.10 Operating the keys

The controls described here expect the pressing of a
(selection) key to be followed by the pressing of a subsequent
key. The next key will need to be pressed within 10 seconds;
otherwise, the selection will be deleted.

5.11 Switching on the hob and cooking zones

1. Press the ON/OFF key (approx. 1 sec.) until a short signal
will sound and the touch control becomes active. The
controls are ready for operation.
2. Put cookware suitable for induction cooking onto the
cooking zone. The pan recognition device will activate the
induction coil. Power setting display of the corresponding
cooking zone shows "0".
3. Use the Power setting display (as a key) to select a
cooking zone. The stand-by dot of the cooking zone
selected will light up.
4. The slider control
immediately afterwards. A power setting will be switched
on.
........left.............. Power setting 0.
........center......... Power setting 6.
........right............ Power setting P
See the section on Worth knowing about the slider
(sensor field).
Press the respective sensor field
change a power setting or to switch on an additional
cooking zone.
Important: the stand-by dot of the cooking zone selected
must light up.
As long as no cooking pot is placed onto the cooking zone,
the display will alternate between the power level set and
the symbol . If no pot is placed on the cooking zone, it
will switch off after 10 minutes for reasons of safety.
Please refer to the Section on pan recognition.

5.12 Switching off a cooking zone

Use the power setting display (as a key) to select a cooking
zone. The stand-by dot of the cooking zone selected must
light up.
5. a) Press the slider area on the far left or
b) drag your finger to the left across the slider control to
reduce the power setting to 0
c) Press the ON/OFF key. All the cooking zones are
switched off.
GB
must be activated
to
22