Programming With The Easy Base Unit - Gewiss Chorus GW 10 776 Manual De Instrucciones

PROGRAMMING WITH THE EASY BASE UNIT

All manuals and user guides at all-guides.com
Programming the channels through the Easy base unit (code GW 90 831).
The channel to be used can be selected, at choice:
• by activating the RF command (when the combination of the RF channels to the
KNX/EIB, as described in the RF Channel Learning process paragraph, has been
completed): the corresponding channel will be highlighted in the channel list in the
"Application ¡ New function" or "Application ¡ Edit function" menu and the front LED
on the receiver will flash green;
• by turning the rotating switch to the channel number to be programmed and pressing
the front button on the receiver: the corresponding channel will be highlighted in the
channel list in the "Application ¡ New function" or "Application ¡ Edit function"
menu and the front LED on the receiver will flash green;
• directly from the list of channels of the "Application ¡ New function" or "Application
¡ Edit function" menus.
The functions can be created after the device has been selected.
Names of the functions on the Easy base unit
switching
timer mode
scene
priority control
dimming
blinds
The chart below lists the base unit functions to be used according to the selected RF
device.
Function
switching
timer mode
scene
priority control
dimming
blinds
Refer to the Easy base unit documentation for further information on the programming
procedures.
ON-OFF command
command ON with timer
(the time is set on the actuator)
scene management command
send priority controls
dimming management command
blinds management command
New: IR with RF command
twilight switch push-button
RF movement panel or RF
detector remote control
I
I
RF timed-
thermostat or RF
bi-directional
timed-thermostat
I I
I
I
I
I
I
27
E
N
G
L
S
H
2 RF channel
input module
I
I
I
I
I
I
I