Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT!
3. The new conduit liner will need to be cut to length.
This can be done by trimming the conduit to the
appropriate length.
4. File the cut conduit end to remove burrs.
5. Replace the contact tip.
6. Replace the nozzle. Hand tighten
(Nozzle secures tip).
For proper operation the nozzle MUST
be tight.
The MIG gun is now ready to be reinstalled on the
feeder.
5.04
REPLACING HANDLE, TRIGGER
Remove the MIG gun from the feeder prior to beginning these steps.
1. Lay MIG gun on side, screw side up and remove both handle screws at the front of the
gun handle.
2. Remove the small screw from the other side of the gun hanger clip and remove the
gun hanger clip being careful to keep all internal components in place.
3. Lay the gun back down on its side and untwist the handle back cap.
4. Remove the top handle half being careful to keep all components in place in the lower
handle half.
5. (Follow this step ONLY if the trigger is to be replaced.) Lift out the molded trigger, the
trigger mechanism, and disconnect the lead wires. Connect the wires to the new trigger
mechanism then place the molded trigger and new trigger in the lower handle half.
6. Place the new top handle half on the old lower handle half and gently flip the gun over.
Replace the old lower handle half with the new lower handle half. Molded trigger should
move within the handle.
7. Flip the gun back to the screw side up and press the handle halves together until they
bottom. Be careful not to pinch the trigger lead wires.
8. Put the gun hanger in place and install the two handle screws. Rotate the gun handle
to the other side and install the small gun hanger clip screw.
9. Slide the Back Cap into place and twist onto the handle end.
The MIG gun is now ready to be reinstalled on the feeder.
89200015
SAFETY AND OPERATING INSTRUCTIONS
All manuals and user guides at all-guides.com
NOTE
Gun Hanger
Handle screws
13
1/8" (3,2 mm)
Conductor Tube
Back Cap
Velocity
Publicidad
