Greenlee 2562 Manual De Instrucciones página 12

Troubleshooting (cont'd)
PROBLEM: TEMPERATURE LED is ON and one or more LEDs are also ON (in addition to the POWER
LED), or the tone sounds continuously.
CAUSE: The charger logic is out of sequence.
SOLUTION: Unplug the charger. Wait for a few seconds and then plug the charger back in. If the problem
persists, move the charger away from sources of strong radio frequency noise, such as portable
communication devices. If the problem still exists, return the charger to an Authorized Greenlee
Service Center.
PROBLEM: When you first put a fully charged battery in the charger, the CHARGING LED comes on,
indicating the battery needs charging.
CAUSE: There is nothing wrong with the battery or charger. During the first 5 minutes, the charger
checks the battery for correct voltage and charge state. During this time the CHARGING LED
is ON. After the checking is complete, the READY LED comes ON.
SOLUTION: Do not "top off" a fully charged battery by repeatedly placing it in charger. The battery
may overheat and may be damaged!
The LEDs on the battery are ON, but the charger READY LED is OFF.
PROBLEM:
CAUSE: The battery displays charge capacity in increments. For example, when the battery reaches 90%
charge, all of the battery LEDS will be ON. The charger READY LED will come ON when the
battery has reached 100% charge.
SOLUTION: Wait for the charger to finish the charge cycle. If the condition does not correct itself, try another
battery. If the condition is corrected, the first battery may be defective. If the condition persists,
the charger is not operating correctly. Return charger to an Authorized Greenlee Service Center.
PROBLEM: The READY LED on the charger is ON, but not all of the battery LEDs are ON.
CAUSE: Possible problem with the charger, or the battery.
SOLUTION: Try recharging a second battery. If the second battery and charger both indicate full capacity at
the end of the charge cycle, then perform the RECONDITIONING operation on the first battery.
If, with the second battery, the charger READY LED also comes ON before the battery LEDs are
ON, then the charger is defective. Return the charger to an Authorized Greenlee Service Center.
PROBLEM: The charger won't go into the RECONDITIONING cycle. The CHARGING LED stays ON.
CAUSE: It has been more than one minute since you inserted the battery.
SOLUTION: Remove the battery and reinsert it into the charger. Manually push the RECONDITIONING
button within one minute of battery insertion.
PROBLEM: You reconditioned the battery, but you do not perceive an increase in battery capacity.
CAUSE: Diminished battery capacity due to age and use.
Power to the charger may have been interrupted during the RECONDITIONING cycle. If a loss
of power occurs, the charger defaults to the normal charge mode. The battery would simply be
recharged at its current state without the benefit of reconditioning.
SOLUTION: If power is lost, remove battery, reinsert, and repeat the RECONDITIONING cycle.
Greenlee Textron / Subsidiary of Textron Inc.
All manuals and user guides at all-guides.com
Battery Charger
4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070
12