FALMEC Modula M2 Manual De Instrucciones página 32

SAFETY DEVICES ON THE COOKER
Safety switch-of
The appliance switches off automatically if the sa-
fety thermostat is triggered.
ELECTRICAL SAFETY
The electrical system which the Teppan
Yaki must be connected to must conform
to the safety regulations in the country of use and
fitted with an earthing connection accordingly. It
must also conform to European standards regar-
ding radio anti-disturbance.
Make sure that the power cable cannot be touched
after it has been recessed and that it is not subject to
mechanical stress. The socket used to connect the in-
stalled appliance to the electrical power supply must
be within reach: otherwise, install a mains switch to
disconnect the appliance when required.
Any changes to the electrical system must be carried
out by a qualified electrician. Do not try to solve the
problem yourself in the event of appliance malfun-
ction, but contact the Dealer or an authorised Servi-
cing Department for repairs.
ELECTRICAL CONNECTION
(only intended for qualified personnel)
Disconnect the appliance from the electrical mains before carrying
out any operation on it.
Make sure that wires inside the appliance are not disconnected or
cut: otherwise, contact the nearest Servicing Centre.
Refer to qualified personnel for electrical connections. Connection must
be carried out in compliance with the provisions of law in force.
Before connecting the Teppan Yaki to the mains, check that:
• the mains voltage corresponds with that indicated on the data plate;
• the electrical system is up to standard and can withstand the load;
• the power supply plug and cable do not come into contact with temperatu-
res exceeding 70 °C;
• the power supply system is effectively and properly connected to earth in
compliance with regulations in force;
• the socket used to connect the cooker is within reach.
In case of:
• devices fitted with cables without a plug: the type of plug to use is a "stan-
dardised" one. The wires must be connected as follows: yellow-green for ear-
thing, blue for neutral and brown for the phase. The plug must be connected
to an adequate safety socket.
• fixed appliance not provided with a power supply cable and plug, or any
other device that ensures disconnection from the electrical mains, with an
opening gap of the contacts that enables total disconnection in overvoltage
category III conditions.
Said disconnection devices must be provided in the mains power supply in
compliance with installation regulations.
The yellow/green earth cable must not be cut off by the switch.
The Manufacturer declines all responsibility for failure to comply with the safety
regulations.
OPERATING AND USING THE TEPPAN YAKI
Control Description
Teppan Yaki switch-on and off
Increases the power level
Decreases the power level
Timer selection for timed switch-off of the Teppan Yaki
(from 1 – 99 minutes)
Front and rear heating zones
Display: indicates the power level (1 – 9) or timer (1 – 99)
Press the
+
keyboard lock. Press the
the keyboard
If the pushbutton panel is completely inactive, before contacting
the Technical assistance service, disconnect power temporarily to
the appliance (about 5"), possibly by acting on the main switch, to
restore normal operation. If this measure has no effect, contact the Techni-
cal assistance service.
The Teppan Yaki allows you to cook on the entire plate or in the front or back
part, with a temperature adjustment from 0 to 250°C, using a touch keypad.
Teppan Yaki allows you to cook meat, fruit, vegetables, etc. using just a little
vegetable fat (butter, oil, lard).
Thoroughly clean the appliance before and after each use.
First switch-on:
• Thoroughly clean all the components
• Heat the plate for about 10 minutes without placing any items or food. The
appliance could emit smoke and odours; this way, the grease used to treat
the heating elements is eliminated
• Ventilate the room
32
and keys simultaneously to activate the
and keys again to unlock