Measurement Procedures - PiC indolor MY Check Instrucciones De Uso

Measurement procedures

Press the ON/OFF/START Key.
1. All digits will light up, checking the display functions. The checking procedure will be completed in few
seconds.
2. After all the symbols appear on the display, a beep will warn
you that the measurement can be taken and a flashing "0"
appears. The monitor is "Ready to Measure" and will auto-
matically inflate the cuff slowly to start measurement.
Cuff tube
Main artery
3. Another beep indicates that the measurement has finished,
after which the armband deflates. Systolic pressure, diastolic
pressure and pulse will be shown simultaneously on the LCD
screen. The measurement is then automatically memorised.
The measurement is then automatically stored into the pre-des-
ignated memory zone. This monitor will reinflate automatically
if the system detects that the cuff needs to be inflated more to
measure your blood pressure.
note:
1. The measurement has to be taken in a silent room.
2. This monitor automatically switches off approximately 4 minutes after last key operation.
3. If the ON/OFF/START key is pressed before 4 minutes have passed, the cuff will begin to reinflate for
a new measurement. If the ON/OFF/START key is held down for 5 seconds the device switches off
immediately.
4. If the ON/OFF/START key is pressed the measurement will be stopped. If a key is pressed the cuff
will immediately deflate.
5. Please refer to the following paragraph for information on memory functions.
All manuals and user guides at all-guides.com
23