Dräger UCF 1600 Instrucciones De Uso página 22

Image capture handle
Fault
LED 1 on the image capture handle flashes.
LED 2 on the image capture handle flashes.
Both LED 1 and LED 2 on the image capture
handle flash.
No image or video can be taken.
22
All manuals and user guides at all-guides.com
Cause
Previously attempted acquisition ended badly. Try to capture the picture/video again.
A picture or video acquisition has been
requested, but a connection to the PC via
USB cable was detected.
A system error has occurred.
An error occurred when writing to the
memory card.
Battery is low.
Remedy
Remove USB cable and try to capture the
picture/video again.
Send image capture handle back to
Dräger Safety.
Check if the memory card or directory is
write-protected. If this is the case, unprotect
memory card or directory. Switch the camera
off and on again and try to capture the picture
or video again.
If the error continues to occur, connect the
USB cable and reformat the memory card.
Recharge battery.