Descargar Imprimir esta página

Stand Assembly; Attaching Frame To Stand - QEP Brutus 60010 Manual De Operación

Publicidad

Idiomas disponibles

Idiomas disponibles

STAND ASSEMBLY

If you are not using the folding stand, set the saw frame
on a solid, flat workbench or table.
B
A
Fig D1
The saw stand includes 2 cross frame supports:
A & B (Fig D1). Laying the frame supports on their sides,
place Frame B inside Frame A (Fig D2).
Fig D3
Use
5/16" x 2" bolts, washers and nuts (Fig D3)
to fasten the frame at the axis. Align holes at axis and place
bolt through hole, from outside in (Fig D4). Place the
washer and nut onto bolt and tighten.
Fig D5
Use two 5/16" x 1
1
" bolts, lock washers and nuts to install
2
the "U" support braces (Fig D5). Fasten the "U" braces to
the top of the horizontal beam of the saw stand (Fig D6).
Place bolt through the aligned holes. From the underside,
place lock washer and nut, then tighten.
Fig D7
3
Use four 1/4" x 1
" bolts, washers and nuts (Fig D7) to
4
attach each wheel to base of Frame B (Fig D8)
B
A
Fig D2
Fig D4
Fig D6
Fig D8

ATTACHING FRAME TO STAND

Fig E1
To attach the Saw Frame to the Stand use the a s s e m b l y
h a rd w a re (Fig. E1). Make sure the wheel brakes are in the
locked position to prevent the Stand from rolling during
assembly (Fig E2). Set the stand on a firm, flat and level
surface. Do not set the stand on soft, uneven ground, or on
debris in the work area. If ground is soft, use a piece of
plywood under the stand to provide a solid and level base.
Fig E3
The Saw will mount directly over the end with the wheels
(Fig E3). Align the frame brackets, on the bottom of the
frame, to the inside of the vertical support pegs on the top
of the stand (Fig E4).
Fig E5
Insert the 1/4" x 3/4" round head bolt into the square hole
of the saw frame and into the stand (Fig E5). Thread the
plastic knob securely onto the bolt, as shown in the
drawing (Fig E6).
- 9 -
Fig E2
Frame
Brackets
Cutter
Head
Wheels
Stand
Support Pegs
Fig E4
Fig E6

Publicidad

Solución de problemas

loading