Noise Level Label; Safety Label; Installation; Hoses And Connections - Chicago Pneumatic CP 0016 Manual De Instrucciones

CP 0016, 4130, 4131, 4132, 4134
D. The warning symbol together with the book
symbol means that the user must read the
safety and operating instructions before the
machine is used for the first time.
E. The CE symbol means that the machine is EC-
approved. See the EC Declaration of
Conformity which is delivered with the machine
for more information.

Noise level label

WA
xxx
dB
The label indicates the guaranteed noise level
corresponding to EC-directive 2000/14/EC. See
"Technical data" for accurate noise level.

Safety label

To avoid injury, before using or servicing tool, read
and understand separately provided safety
instructions.

Installation

Hoses and connections

A
B
A. Compressed air source
B. Water separator (optional)
C. Oiler (optional)
D. Max. 10 feet (3 meter) compressed air hose
between the oiler and the machine.
9800 0616 71 | Original instructions
All manuals and user guides at all-guides.com
D
C
Safety and operating instructions
◆ Check that you are using the correct
recommended operating pressure, 87 psig (6
bar (e)).
The maximum permissible air pressure, 90 psig
◆
(6.2 bar (e)), must not be exceeded.
◆ Blow any impurities out of the compressed air
hose before connecting it to the machine.
Select the correct dimension and length for the
◆
compressed air hose. For hose lengths up to
100 feet (30 meters), a hose with a minimum
internal diameter of ⁄
3
4
used. If the hose length is between 100 and
330 feet (30 and 100 meters), a hose with a
minimum internal diameter of 1 in. (25 mm)
should be used.

Methods to prevent freezing

Ice formation in the muffler can occur when the
ambient air temperature is 32-50°F (0-10°C) and
the relative humidity is high.
The machine is designed to avoid the formation of
ice in the muffler. Despite this, under extreme
conditions ice can form in the muffler.
The following actions can be taken to further
counteract the risk of ice formation:
◆ Use CP Airolene Plus Tool Oil as a lubricant.
CP Airolene Plus Tool Oil counteracts freezing.
Use a water separator.
◆

Connecting a water separator

The length of the air hose between the compressor
and the water separator must be such that the
water vapour is cooled and condenses in the hose
before reaching the water separator.
If the ambient temperature is below 32 °F (0 °C)
the hose must be short enough to prevent the
water from freezing before reaching the water
separator.

Lubrication

The lubricant is important for the machine's
function and has a great impact on the service life.
In order to supply the correct volume of oil, an oiler
should be connected to the air hose. The use of a
Chicago Pneumatic air line oiler is recommended.
To guarantee good lubrication, the length of the air
hose between the oiler and the pneumatic tool
should not exceed 10 feet (3 m).
Too much lubrication can cause starting problems,
low power or uneven performance.
in. (19 mm) should be
15