Publicidad
Idiomas disponibles
Idiomas disponibles
4. Attach the Bracket to the threaded holes in the frame with (2) 12mm x 45mm Hex bolts, (2) 12mm Lock
Washers and (2) 12mm Flat Washers, (Figures 5 & 6).
5. With assistance, hold the Bull Bar up in position on the outside of the Mounting Brackets. Attach the Bull
Bar to the Brackets with (4) M8 Bolt Assemblies, (Figure 7). Do not tighten hardware at this time.
6. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
(Fig 5) Attach driver/left Bracket to
bottom of frame. (Under vehicle view)
(Fig 7) Attach Bull Bar to Mounting Bracket using
M8 Bolt Assembly.
(For illustration purposes, shown off vehicle)
To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer over
the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish. Mild soap may be
used also to clean the Bull Bar.
(2) 12mm Hex Bolts
(2) 12mm Lock Washers
(2) 12mm Flat Washers
(Fig 6) Front view of bracket mounted.
Completed Installation
4
I-Sheet Number 20263 Rev.A
REVOLUTION™ BULL BAR
2019 FORD RANGER
Publicidad
