Aroma Plus Function; Quick Start - CASO DESIGN Selection C 10 Thermo Manual Del Usuario

13.2.4

Aroma Plus function

Activate the Aroma Plus function for more intense taste. For that hold the
until is displayed. The selected aroma intensity is safed.
Deactivating aroma mode: Press and hold the button
off.
► It is not possible to change the aroma setting if the brewing process has already started.
► If you pull the mains plug, your settings (including the activation of the aroma strength)
will be deleted.
13.2.5

Quick start

► Rinse the insulated jug with warm water before use.
1. Complete the "Preparations".
2. Start the brewing process: press the button
device starts the brewing process with the previously set aroma strength.
3. The red dot in the display switches off after about a minute when the brewing
process is completely finished.
► You can stop the brewing process at any time with the button
switches off.
► The amount of brewed coffee may differ from the amount of water as coffee ground
absorbs different amount of water depending on the amount and degree of grinding of
the coffee ground
► The device is equipped with a drip stop system which enables you to serve coffee
before all the water has dripped through. Quickly put the coffee pot back in place to
avoid any overflowing.
► Do not fill hot water into the watertank.
► Never fill the water tank beyond top mark.
► Wait a few minutes before brewing coffee again. Let the device cool down.
► The warming heats during brewing process. Danger of burns.
► Switch the device off when you have removed the last coffee from the coffee pot. Do not
place empty coffee pot on the plate.
Please note
Warning
until the display
, the red LED lights up and the
. Then the red LED
button
switches
34