Timer Mode; Cleaning And Maintenance; Safety Information; Cleaning - CASO DESIGN Selection C 10 Thermo Manual Del Usuario

13.3 TIMER mode

Finish the „preparations". Press
When the hour digits are flashing, turn the knob to set the hours. Then wait 3 seconds until
the device switches to the minute display. When the minute digits start to flash, turn the
knob to set the minute. Wait briefly (approx. 5 seconds) until the device saves the setting.
► You can end the TIMER mode by pressing the
out.

13.4 Cleaning and Maintenance

This chapter provides you with important notices with regard to cleaning and maintaining
the device. Please observe the notices to prevent damages due to cleaning the device
incorrectly and to ensure trouble-free operation.

13.5 Safety information

Attention
Please observe the following safety notices, before you commence with cleaning the
device:
► The device must be cleaned at regular intervals and limescale should be removed.
► Pull out the mains plug before cleaning the device.
► The water tank, coffee pot and filter holder with filter are hot after their use. There is a
danger of burns! Wait until the device has cooled down.
► Do not use any aggressive or abrasive cleaning agents or solvents.
► Do not scrape off stubborn dirt with hard items.

13.6 Cleaning

Remove the coffee grounds from permanent filter or discard the paper filter with coffee
grounds. Thoroughly rinse the permanent filter and filter holder under running water. Rinse
the coffee pot. The device can be wiped with a damp cloth.
Dry all parts thoroughly.
► Do not clean the device when it is hot.
► Never put the device in water or under running water.
► Be sure to unplug the device before cleaning. To protect against electrical shock do not
immerse cord, plug or device in water or liquid.
twice until TMER symbol lights up.
Please note
Warning
button again. The white LED goes
35