Yamaha R-S700 Manual De Instrucciones página 7

A TUNING jj / ii
Selects the tuning frequency when TUNER is selected as
the input source (see page 18).
B Remote control sensor
Receives infrared signals from the remote control.
Note
Switch the remote control ID between ID1 and ID2 when using
multiple Yamaha receivers or amplifiers (see page 35).
C CD DIRECT AMP and indicator (R-S700 only)
Allows you to listen to a CD source in the purest possible
sound (see page 15). The indicator lights up and the front
panel display turns off when this function is turned on.
Note
If both the CD DIRECT AMP and the PURE DIRECT are turned
on, only the CD DIRECT AMP will function.
D PURE DIRECT and indicator
Allows you to listen to a source in the purest possible
sound (see page 15). The indicator above it lights up and
the front panel display turns off when this function is
turned on.
E PHONES jack
Outputs audio to your headphones for private listening.
Note
Press SPEAKER A/B so that the SP A/B indicators turn off
before you connect your headphones to the PHONES jack.
F REC OUT selector
Selects a source for recording to a CD recorder or to a tape
deck independently of the INPUT selector setting,
allowing you to record the selected source while listening
to another source (see page 17).
G BASS control
Increases or decreases the low frequency response. The
center position produces a flat response (see page 16).
H TREBLE control
Increases or decreases the high frequency response. The
center position produces a flat response (see page 16).
I BALANCE control
Adjusts the sound output balance of the left and right
speakers to compensate for sound imbalances caused by
speaker locations or listening room conditions (see page
16).
J LOUDNESS control
Retains a full tonal range at any volume level to
compensate for the human ears' loss of sensitivity to high
and low-frequency ranges at a low volume level (see page
16).
K INPUT selector
Selects the input source you want to listen to.
All manuals and user guides at all-guides.com
L VOLUME control
Increases or decreases the sound output level.
Note
This does not affect the output level of the REC jacks.
CONTROLS AND FUNCTIONS
5
En