Metabo HPT DH3628DD Instrucciones De Seguridad Y Manual De Instrucciones página 11

(3) With the end of the nozzle still in fi rm contact with the
surface of the concrete, proceed with drilling. (Fig. 18)
5. Emptying the dust
If too much dust is collected in the dust box, the dust
extraction performance declines.
Additionally, if the dust box is full, dust may leak out of
the dust extractor system.
Inspect the dust extractor system regularly, and
dispose of the dust before it becomes full.
WARNING
When emptying the dust, in order to prevent an
unlikely accident, be sure to turn off the tool's
switch and remove the rechargeable battery
from the tool body.
CAUTION
Wear a dust mask.
Firm contact with the
concrete surface
Drilling
Raised off the
concrete surface
Fig. 18
(1) Detach the dust box (Fig. 19)
Dust housing
Dust box
(2) Clean out the dust in the cyclone chamber (Fig. 20)
Dust box cover
(3) Press in the 2 latches on the sides of the fi lter cover,
then pull up and remove the fi lter set. (Fig. 21)
Pull up
Press in
English
Dust box
latch
Fig. 19
Cyclone chamber
Fig. 20
Filter
Press in
Latches of
fi lter cover
Filter chamber
Fig. 21
11