Publicidad
Idiomas disponibles
Idiomas disponibles
State of lamp
Lights ;
The battery remaining power is
over 75%.
Lights ;
The battery remaining power is
50%–75%.
Lights ;
The battery remaining power is
25%–50%.
Lights ;
The battery remaining power is
less than 25%.
Blinks ;
The battery remaining power is
nearly empty. Recharge the battery
soonest possible
Blinks ;
Output suspended due to high
temperature. Remove the battery
from the tool and allow it to fully cool
down.
Blinks ;
Output suspended due to failure or
malfunction. The problem may be
the battery so please contact your
dealer.
The Table 7 shows the state of remaining battery indicator
lamp and the battery remaining power.
NOTE
Do not give a strong shock to the display panel or
break it. It may lead to a trouble.
TRANSPORTATION OF THE MAIN BODY
The vice assembly could be dropped during transportation.
Either remove the assembly or slip a piece of wood
between the vice to fi rmly secure it.
Drop the head and insert the locking pin (page 14
"4. Releasing the locking pin").
Turn and loosen the side handle, turn the turntable as far
right as it will go, and secure the turntable by turning the
handle to the fi xed position. This will make the main body
even more compact.
Table 7
Battery Remaining Power
When transporting the main body, carry it in your arms,
holding the grip located on the base with both hands or
carry handle.
Carry Handle
Base Grip
Piece of wood to
secure the vice
MAINTENANCE AND INSPECTION
WARNING
To avoid an accident or personal injury, always
confi rm the trigger switch is turned OFF and
that the battery has been disconnected from the
power tool before performing any maintenance
or inspection of this tool.
Report to qualifi ed person as soon as possible,
if you discover the fault of machine including
guards or blade saw.
1. Inspecting the saw blade
Always replace the saw blade immediately upon the
fi rst sign of deterioration or damage.
A damaged saw blade can cause personal injury and
a worn saw blade can cause ineff ective operation and
possible overload to the motor.
CAUTION
Never use a dull saw blade. When a saw blade is
dull, its resistance to the hand pressure applied
by the tool handle tends to increase, making it
unsafe to operate the power tool.
2. About Handling the Motor (see Fig. 2)
Winding of the motor is said to be the heart of this tool.
Exercise utmost caution not to damage the winding by
exposing it to wash oil or water.
English
Head
Side Handle
Vice Assembly
Fig. 38
29
Publicidad
