Publicidad
Idiomas disponibles
Idiomas disponibles
English
● To avoid injury from an accidental start, turn the switch OFF and remove the plug from the power source
or remove the battery or AC/DC adapter from the main body before making any adjustments.
● All electrical or mechanical repairs should be done only by qualifi ed service technicians. Contact
metabo HPT Authorized Service Center.
1. Power tool
Problem
Tool doesn't run
Tool suddenly stopped
Cannot be tilted
Sawblade is dull
Cannot cut with precision
Switch cannot be pulled
Battery cannot be
installed
Remaining battery
indicator on the tool does
not match that on the
battery
32
TROUBLESHOOTING GUIDE
WARNING
Possible Cause
No remaining battery power.
The battery is not fully installed.
Tool was overburdened.
The battery is overheated.
The clamp lever has not been loosened.
The sawblade is worn down or missing
teeth.
Bolt is loose.
The sawblade has been installed in
reverse.
The operation parts of the tool are not fully
fi xed.
Material cannot be fi xed in the correct
position.
Lock-off button is not pressed in enough.
Attempting to install a battery other than
that specifi ed for the tool.
―
Possible Solution
Charge the battery.
Insert the battery into the tool until you hear
a click.
Get rid of the problem causing the
overburden.
Let the battery cool down.
Loosen the clamp lever and then tilt the
tool.
After adjusting the loosened component,
make sure to tighten it once again.
Exchange with a new product.
Tighten the bolt.
Install the sawblade in the correct direction.
Fully install the clamp lever and side
handle.
Remove any foreign material from the
fence or turntable.
In some cases, proper position cannot be
fi xed due to a curve in the material.
Try to fi x a fl at surface with the fence or
turntable.
Press in the Lock-off button all the way until
it strikes the back.
Please install batteries that are multi volt or
BSL18xx series.
Refer to the indicator lamp on the battery.
Publicidad
