Connecting With Cleaner; Maintenance And Inspection - Metabo HPT CJ 90VST2 Manual De Instrucciones

English

CONNECTING WITH CLEANER

By connecting with cleaner (sold separately) through dust
collection adapter and adapter (sold separately), most of
dust can be collected. (Fig. 22)
Base
Dust collection
adapter

MAINTENANCE AND INSPECTION

WARNING
Be sure to switch power OFF and disconnect the plug from the receptacle during maintenance and
inspection.
1. Inspecting the blade
Continued use of a dull or damaged blade will result in reduced cutting effi ciency and may cause overloading of the
motor. Replace the blade with a new one as soon as excessive abrasion is noted.
2. Maintenance of the motor
The motor unit winding is the very "heart" of the power tool. Exercise due care to ensure the winding does not
become damaged and/or wet with oil or water.
WARNING
Using this Jig Saw with loosen screws is extremely dangerous.
3. Maintenance of the motor
The motor unit winding is the very "heart" of the power tool. Exercise due care to ensure the winding does not
become damaged and/or wet with oil or water.
4. Service and repairs
All quality power tools will eventually require servicing or replacement of parts because of wear from normal use.
To assure that only authorized replacement parts will be used, all service and repairs must be performed by a
metabo HPT AUTHORIZED SERVICE CENTER, ONLY.
CAUTION
In the operation and maintenance of power tools, the safety regulations and standards prescribed in
each country must be observed.
14
Adapter
Nose
Cleaner
Fig. 22
(1) Loosen the base bolt hexagonal bar wrench attached
on base. (Fig. 12)
(2) Move the base fully forward, and tighten the base bolt
again. (Fig. 12)
(3) Connect the dust collection adapter with adapter.
(Fig. 22)
(4) Connect the adapter with the nose of cleaner.
(Fig. 22)
(5) Insert dust collection adapter into the rear hole
of the base until the hook catches in the notch.
(Fig. 23)
(6) Press the hook to remove the dust collection adapter.
Hook
Rear
Base
Dust collection
hole
adapter
Notch
Adapter
Fig. 23