Mounting Or Removing The Arm Support; Mounting/Taking Off The Rear Wheels (If Available); Storage - Vermeiren Eclips X2 Kids Manual De Instrucciones

EN
NL
To unfold:
1. Position yourself behind the wheelchair.
2. Use the handgrips to open the wheelchair as much as possible.
3. Position yourself at the front of the wheelchair.
4. Push both seating tubes down until they are fixed in position.
2.7

Mounting or removing the arm support

CAUTION
 Check that the arm pads are at the same height on each side.
1
3
2.8

Mounting/Taking off the rear wheels (if available)

To remove the rear wheels
1. Press and hold button (1) while sliding the wheel axle out of the
hole of the frame.
2. Repeat this for the other wheel and place the wheelchair gently
on the rear frame tubes.
To install the rear wheels
1. Take one of the rear wheels and lift the wheelchair on one side.
2. Press and hold button (1) while sliding the wheel into the axle
bushy.
3. Release the button to lock the wheel. Make sure it clicks into
place.
4. Repeat this for the other wheel.
5. Ensure that both wheels are firmly secured.
2.9

Storage

Make sure that your wheelchair is stored in a dry environment to prevent mould from
growing and the upholstery from being damaged, see also chapter 6.
Risk of injuries and/or damage
2
Mount the armrest (1) by sliding the support rod (2) down into the
frame (3).
To remove the armrest (1), lift it up and out of the seat frame.
Eclips X2 Kids, Eclips X2 30° Kids
6
2022-06
Before use