Mounting Or Removing Of The Footrest; Operating The Brakes; Mounting Or Removing Of Armrests - Vermeiren D200 Manual De Instrucciones

2.4

Mounting or removing of the footrest

2.5

Operating the brakes

L
WARNING:
The brakes are not used to slow down the wheelchair during
movements – Use the brake only to prevent the wheelchair from unintended
movements.
L
WARNING:
Good operation of the brakes is influenced by wear and
contamination of the tires (water, oil, mud, ...) – Check the condition of the tires
before each use.
L
WARNING:
The brakes are adjustable and can wear – Check the operation of the
brakes before each use.
L
WARNING:
Risk of clamping - Do not touch the wheelchair frame with your
hands, fingers when applying, releasing the brakes.
To apply the brakes:
1. Push the brake handles forward till you feel a distinctive click.
L
CAUTION:
Risk of unintended movement – Make sure the wheelchair is on a
flat horizontal surface before releasing the brakes. Never release both brakes
simultaneously.
To release the brakes:
1. Release one brake by pulling the handle backwards.
2. Hold the hand-rim of the released wheel with your hand.
3. Release the second brake by pulling the handle backwards.
2.6

Mounting or removing of armrests

The arm supports of the wheelchair can be mounted by following instructions.
L
CAUTION:
Risk of clamping – Keep fingers, buckles and clothes away from the
bottom side of the armrest.
L
CAUTION:
Risk of clamping – Be careful that your fingers, hands are not
squeezed between the rear wheels and the side plate of the armrests.
The mounting of the footrest is done as
follows:
1. Hold the footrest sideways at the outside
of the wheelchairs frame and mount the

tube hood into the frame.
2. Swing the footrest inwards till it clicks in
position.
3. Swing the foot plate downwards.
To take off the footrests:
1. Pull handle .
2. Swing the footrest to the outside of the
wheelchair till it comes loose from the
guidance.
3. Pull the footrest from tube hood
Page 8
D200
2014-08

.