Additional Information; Understanding Built-In Cd Player Error Messages; Understanding Auto Ta And Eq Error Messages - Pioneer DEH-P8850MP Manual De Instrucciones

Reproductor de cd/mp3/wma/aac de alta potenciacon sintonizador de fm/am, dsp y control de cdmúltiple
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

www.DataSheet4U.com

Additional Information

Understanding built-in CD
player error messages
When you contact your dealer or your nearest
Pioneer Service Center, be sure to record the
error message.
Message
Cause
ERROR-11, 12,
Dirty disc
17, 30
ERROR-11, 12,
Scratched disc
17, 30
ERROR-10, 11,
Electrical or me-
12, 15, 17, 30,
chanical
A0
ERROR-15
The inserted disc
does not contain
any data
ERROR-23
The CD format
cannot be played
back
NO AUDIO
The inserted disc
does not contain
any files that can
be played back
TRK SKIPPED
The inserted disc
contains WMA
files that are pro-
tected by DRM
PROTECT
All the files on
the inserted disc
are secured by
DRM
Understanding auto TA and
EQ error messages
When correct measurement of car interior
acoustic characteristics is not possible using
the auto TA and EQ, an error message may ap-
pear on the display. If an error message ap-
pears, refer to the table below to see what the
problem is and the suggested method of cor-
recting the problem. After checking, try again.
Message
Check MIC
type
Action
MIC ERROR
Clean disc.
Replace disc.
Front Speaker
Turn the ignition
ERROR, Front
ON and OFF, or
left Speaker
switch to a differ-
ERROR, Front
ent source, then
right Speaker
back to the CD
ERROR, Rear
player.
left Speaker
ERROR, Rear
Replace disc.
right Speaker
ERROR, Sub-
woofer
Replace disc.
ERROR, Sub-
woofer Lch
ERROR, Sub-
Replace disc.
woofer Rch
ERROR
Noise ERROR
Replace disc.
Replace disc.
Black plate (69,1)
Cause
Action
Microphone is
Disconnect the mi-
connected to mi-
crophone.
crophone input.
Microphone is
Plug the supplied
not connected.
microphone se-
curely into the
jack.
! Confirm that the
The microphone
cannot pick up
speakers are con-
the measuring
nected correctly.
! Cancel muting
tone of a speaker.
the front speaker
units.
! Correct the input
level setting of the
power amp con-
nected to the
speakers.
! Set the micro-
phone correctly.
! Stop your car in
The surrounding
noise level is too
a place that is as
high.
quiet as possible,
and switch off the
engine, air condi-
tioner or heater.
! Set the micro-
phone correctly.
<CRD4089-A/N>69
Appendix
69
En

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido