Correcting Distorted Sound; Switching The Sound Muting/Attenuation; Switching The Feature Demo - Pioneer DEH-P8850MP Manual De Instrucciones

www.DataSheet4U.com
Section
Initial Settings
12
2 Push MULTI-CONTROL left or right to
adjust the brightness level.
Each time MULTI-CONTROL is pushed left or
right, brightness level increases or decreases.
0 to 31 is displayed as the level is increased or
decreased.
# When dimmer is functioning, the brightness
level can be adjusted 0 to 21.

Correcting distorted sound

When listening to a CD or other source on
which the recording level is high, setting the
equalizer curve level to high may result in dis-
tortion. You can switch the digital attenuator
to low to reduce distortion.
! Sound quality is better at the high setting
so this setting is usually used.
1 Use MULTI-CONTROL to select
Digital ATT.
Digital ATT appears in the display.
2 Press MULTI-CONTROL to select the di-
gital attenuator level.
Pressing MULTI-CONTROL repeatedly will
switch between High (high) and Low (low)
and that status will be displayed.
Switching the sound
muting/attenuation
Sound from this system is muted or attenu-
ated automatically when the signal from the
equipment with mute function is received.
! The sound is muted or attenuated, MUTE
or ATT are displayed and no audio adjust-
ment is possible.
! Sound from this system returns to normal
when the muting or attenuation is can-
celed.
62
En
Black plate (62,1)
1 Use MULTI-CONTROL to select Mute.
Mute appears in the display.
2 Press MULTI-CONTROL to select the de-
sired setting.
Press MULTI-CONTROL repeatedly to switch
between the following settings:
! TEL mute – Muting
! 10dB ATT – Attenuation
! 20dB ATT – Attenuation (20dB ATT has a
stronger effect than 10dB ATT)

Switching the feature demo

The feature demo automatically starts when
power to this unit is turned off while the igni-
tion switch is set to ACC or ON.
1 Use MULTI-CONTROL to select
Demonstration.
Demonstration appears in the display.
2 Press MULTI-CONTROL to turn the fea-
ture demo on.
ON appears in the display.
# To turn the feature demo off, press
MULTI-CONTROL again.
Notes
! Remember that if the feature demo continues
operating when the car engine is turned off, it
may drain battery power.
! You can also turn on or off feature demo by
pressing DISPLAY while this unit is turned off.
For more details, see Feature demo mode on
page 8.
<CRD4089-A/N>62