SUPAIR ACCESS 2 BUMP Manual De Instrucciones página 52

Harness User's manual | ACCESS 2 BUMP
>> Access to the reserve parachute connection points.
First, open the riser guiding sleeve all the way from top to bottom to access the reserve parachute connec-
tion loops. Once the riser guiding sleeve is fully opened, the zipper tab must be located on the same side of
the reserve parachute pocket.
A
Fastening the risers to the harness via a Lark's head knot connection.
Attach each riser to the shoul-
1
der attachment points by making
a Lark's knot ( loop to loop con-
nection ). Use the largest bridle
loop ends.
Fastening the risers to the harness with a set of 6mm square Maillons Rapides®
B
Take two 6mm square
Maillons Rapides® and
two toric elastic rings.
Open the 6mm mail-
1
lon Rapide®
- Push the toric ring
through the Maillon
Rapide® and twist it.
INSTALLING THE RESERVE PARACHUTE
Riser/Harness connection
Assemble everything cor-
2
rectly.
Make sure for the risers not to
be longer than one another.
Push the bridle
2
connecting point
through the toric
ring loop
- Push the Maillon
Rapide® through the
bridle connection
loop.
Give the toric ring
3
a second twist
- Push the bridle
through the Maillon
Rapide®
- Make sure the riser
stays in place.
We recommend using
"split" risers to guaranty
a clean reserve para-
chute deployment.
Tighten each connection securely.
3
Close the mail-
4
lon Rapide® by hand,
then tighten using a
set of pliers and mak-
ing a 1/4 turn.
- Repeat the proce-
dure with the second
bridle connection
loop.
ACCESS 2 BUMP | page 14