Optional Accessories - Makita DTR181 Manual De Instrucciones

Error display and error tone
CAUTION:
During inspection, be sure to lock the trigger, turn the power off, and remove the battery
cartridge. Failure to do so may cause an accident.
CAUTION:
When you turn the power on, never bring your limbs or face close to the binding or rotating
parts of the tool tip. Otherwise, you may be injured.
CAUTION:
When the power is turned on, never touch the binding or rotating parts of the tool tip.
Otherwise, you may be injured.
CAUTION:
If an error tone sounds, or if the tool malfunctions, immediately stop using the tool.
Error tone and display
If an error occurs, an error tone will sound, and an error number will be shown on the display panel. Refer to the
following table and take appropriate actions. If the error persists, ask Makita Authorized Service Centers for repairs.
Display
1
2
3
4
5
6
7

OPTIONAL ACCESSORIES

CAUTION:
These accessories or attachments
are recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
• Tie wire
• Wire guide B complete (EG)
• Wire brush
• Extension handle
• Makita genuine battery and charger
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
Symptom
The tool stops operating.
The tool stops operating.
The tool does not perform the
tying process in continuous
actuation mode.
The tool does not start.
The tool stops operating.
The tool stops operating.
The tool stops operating.
The tool does not start.
The tool stops operating.
Possible cause
The wire has been used up.
Tie wire is not loaded.
Wire feeding has failed.
The curl guide is open.
The contact plate is caught.
The battery has been
discharged.
The temperature of the battery
cartridge is abnormally high.
The motor is overloaded.
Motor failure
The temperature of the tool is
abnormally high.
Tool failure
22 ENGLISH
Solution
Load new tie wire.
Load tie wire.
Check the orientation of the
tie wire.
Unload the tie wire, and load
it again.
Clean the path of wire.
Close the curl guide.
Release the contact plate from
being caught.
Recharge the battery.
Cool the battery cartridge
down.
Replace the battery cartridge
with a recharged one.
Determine the cause of the
obstruction of the motor rotation
and solve the problem.
Cool the tool down.
Ask Makita Authorized Service
Centers for repairs.