Desoutter CVI3 Manual Del Usuario página 4

6159920530
Issue no: 04
BIT TRAY CONNECTION
1
Legend
1 Termination plug SubD 9-pt
2 eBUS cable connection
Put the termination plug when:
- The bit tray is unique on the eBUS
network.
- The bit tray is the last accessory on
the eBUS network.
CONTROLLER CONNECTION
● Connect the eBUS cable to the bottom panel
of the controller (see below).
24V-1A is supplied from the controller to
power the bit tray.
Legend
9 Controller eBUS port
Max current: 110 mA @ 24V DC.
2
9
BIT TRAY POSITION
Legend
1 Encoding wheel
● Remove the cap from the encoding wheel.
● By using a screwdriver, select the position
number of the bit tray on the eBUS cable:
(1-9 and A-F), 1 being the first position, F the
last (F=15).
● Do not put the accessory in use when
the encoding wheel is set to "0".
● Put the cap back on the wheel.
BIT SETTING
1
2
Legend
1 Bit hole
2 Screw
● Insert the bit in the hole.
● Turn the screw clockwise for a heavier bit
and counter-clockwise for a lighter bit.
4 / 40
1
02/2020