Publicidad
Idiomas disponibles
Idiomas disponibles
Spotlight LED 50AP
General information
Water temperature must not exceed +40ºC.
Water must not freeze around the lamp.
Lamp must be completely immersed in the water when lit up
Recommended water quality values:
Total chlorine content: max 3.5 mg/liter (ppm)*
Chloride (salt) content: max 250 mg/liter
pH-value:
7.2–7.6
Alkalinity:
60–120 mg/liter (ppm)
Calcium hardness:
100–300 mg/liter (ppm)
Iron:
max 0.1 mg/liter *
Copper:
max 0.2 mg/liter *
Manganese:
max 0.05 mg/liter *
Phosphorus:
max 0.01 mg/liter *
Nitrate:
max 50 mg/liter *
Outside these values the product warranty does not apply.
* In accordance with EN 16713-3
Installation in general
• Electrical installations of >30V must not be placed within 500 mm of any stainless steel material.
• Installation requires the use of stainless steel tools with clean contact surfaces.
• Store the products in the original packaging until installation in order to avoid scratches and stains.
• Exercise caution during installation so that the product is not scratched.
• Avoid placing concentrated amounts of chemicals next to stainless steel components. A lack of circulation in the pool may
result in damage.
• Keep in mind that the lamp cannot withstand exposure to sub-zero temperatures. If there is a risk of this occurring, the lamp
should be disassembled.
Electric installation
Comply with local electricity regulations with regard to the location of the connection box.
The lighting must always be connected via a protective transformer 12V AC (see table) in order to obtain the correct function
and a maximum useful life. If more than one RGB lamp is installed, these must be connection to the same transformed and via
a common switch in order for them to be synchronised.
The transformer's power must be greater than the total value of all the lamps, see the table on the next page. The accompanying
cables must always be used for connecting the lamp.
If the external cable insulation for the lighting or inner conductor is damaged, it must be replaced by a service technician or other
qualified person.
Recommendations
The following recommendations concerning cables and the connection of the lamps must be followed in order to obtain the
desired function. Maximum and stable light is only guarantee if the cross-section of the cable is equal to or greater than the
stated values. The cable lengths are calculated for the greatest conceivable power loss in the cables.
Alternative 1.
All lamps are connected directly to the
transformer with a separate cable.
This solution is preferably when the control
unit PLP-REM or PLP-REM300 is used.
230VAC
Cable that comes with the lamp
Separate cable, not included
page 8 of 20
Max cable length
12VAC
12
RGB light's colour modes:
Fixed position
1. Saturated blue
2. Light blue
3. Orange/red
4. Red
5. Green
6. Pink
7. Yellow
Dynamic mode
8. Switch slowly between various blue nuances
9. Switch slowly between various red nuances
10. Switch quickly between six colours
11. Switch quickly between all colours
White colours
12. Warm white
13. Neutral white
14. Sun white
Alternative 2.
Wiring instructions Setup 2
All lamps are connected to the transformer via a supply cable and a
All lamps are connected to the transformer via 1 cable
connection box.
230VAC
12VAC
Cable that comes with the lamp
Separate cable, not included
page 10 of 20
ENGLISH
Max cable length
Junction
Junction
box
box
Publicidad
