How To Install - Pahlen 50AP Manual Del Usuario

Spotlight LED 50AP
Cont'd (For Pool Structures Made of Wood, Sheet Metal or Plastic - with Liner)
Dimension drawing for hole in pool wall


How to Install:

1. Make a hole in the structure according to the dimensioned drawing.
Recommended depth for the lamp is 300–800 mm down from the pool edge.
2. Attach the flange with screws from the inside of the pool and the included attaching ring against the outside of the structure
(see drawing).
3. Attach the self-adhesive gasket onto the flange.
4. Install the plug on the rear edge of the flange. If an O-ring is being used, no other seal is necessary.
5. Install the cable bushing in the plug. Use the included O-ring and make sure that it is resting in the correct location.
No further sealing is required.
6. Install the pool liner according the the supplier's instructions and begin filling with water.
7. Once the water has reached a level approximately 5 cm under the flange, cut a small cross in the pool liner in the centre of
the hole.
8. Attach the gasket and sealing ring with 6 screws.
9. Trim the liner along the inner edge of the sealing ring.
10. Thread the cable through the cable socket fitting and pull it out at the front side of the flange.
11. Thread the sealing grommet onto the cable. The sealing grommet must be placed in the rubber on the cable socket fitting.
12. Attach the LED module on the cable in accordance with the instructions on page 13.
13. Carefully pull the LED module cable on the flange.
14. Tighten the cable socket fitting so the the cable rests firmly in place.
Make sure that the sealing grommet is placed in the rubber on the cable socket fitting.
N.B.! Leave a sufficient length of cable free on the rear side of the pool wall,
or in the connection box for future service or any winter closure.
15. Clamp the LED module in place with the front. Tighten it in place with two screws.
16. Fill the pool with water to the desired level.
Inloppsmunstycke / Inlet
Sugmunstycke / Outlet
Spa-belysning / Spa light
78

6 (4x)
UP

70-75
UP
NOTE! Not 1:1 scale
due to technical reasons
15
ENGLISH
UP
Flange
UP
Sealing ring
M12646-0