Publicidad
Idiomas disponibles
Idiomas disponibles
13. Remove the middle cover. Carefully pull the PCB board and headlight board through
the middle cover. Then pull the two motor wires through the middle cover. Pay attention
to reserve the two felt washers properly for re-installation.
Felt
Washers
shown and release the non-belt side from the base.
15. Remove the belt side of the agitator. Use a suitable tool (e.g. a screwdriver) to carefully
pry off the end cap at position 1 as shown, and then release the belt side from the
base.
1
Motor Wires Wood Agitator
PCB Board
II
Headlight Board
I
-37-
Middle Cover
Publicidad
