Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Vision Safety glasses with side
shields. Always use eye protection
which is marked to comply with
standard.
SPECIFIC TIMMMER
SAFETY RULES
Replace the trimmer head if
cracked, chipped or damaged in any
way. Be sure the trimmer head is
properly installed.
Use only the manufacturer's
replacement wire in the trimmer
head.
Never operate the product without
the safety guard in place and in
good condition.
Use the product for cutting grass
and light weeds only. Do not use for
any other purpose.
Before starting the product, position
it so that the wire does not come in
contact with anything.
Maintain a firm grip on both handles
while working.
Keep the working area free from
wires, stones and debris.
Do not use the trimmer to cut grass
which is not in contact with the
ground, for example, do not cut
grass which is on walls or rocks etc.
Always use your trimmer in an
upright position.
Keep hands away from the cutting
edge, do not attempt to move cut
material or to hold material to be
cut when the wire is moving. Be
sure to unplug the product before
clearing jammed material from the
wire.
Never fit metal cutting elements to
the trimmer.
SAVE THESE
INSTRUCTIONS
SERVICE
Servicing requires extreme care
and knowledge and should be
performed only by a qualified
service technician. For service we
12
suggest you return the product to
your nearest authorized service
centre.
ASSEMBLY & OPERATION
WARNING
If any parts are damaged or
missing, do not operate this tool
until the parts replaced.
Failure to heed this warning could
result in serious personal injury.
Do not attempt to modify this
product or create accessories not
recommended for use with this
product. Any such alteration or
modification is misuse and could
result I a hazardous condition
leading to possible serious.
To prevent accidental starting that
could cause serious personal injury.
Always disconnect the power cord
from the power supply before
assembling and adjusting.
Never use the machine without
protection. It is essential for safety
and for the operation for the tool. If
this instruction is not observed, this
will rule out all warranty claims.
PROTECTIVE EQUIPMENT
ASSEMBLY
Fig. 1
Blade
Protector
Shield
Driver
Screw
See figure 1. The protection is
provided with a sharp blade to cut
the nylon thread. To avoid injury,
make sure that the protection is
in the correct position. Fit the
protection on the sideboard of the
body and secure using the supplied
screw.
ADJUSTING THE ANGLE
OF THE AUXILIARY
HANDLE
Fig. 2
To adjust the handle angle,
press the two side buttons
and turn to the desired
position.
Housing
Publicidad
