Important - Beta 972/C10 Instrucciones

REMOVAL TOOL ASSORTMENT FOR DAMAGED WHEEL FIXING BOLTS
SAFETY INSTRUCTIONS AND WARNING
Make sure that health and safety standards as well as the provisions established by
local authorities and general good practice standards applicable to garages are
complied with while using tools. DO NOT use any damaged tools. Keep your tools in
a good state of repair and clean for optimal performance and unparalleled safety.
Wear approved eye protection. Wear clothes that will not get caught in the tools.
Keep all the tools and parts being used under control and do not leave them in the
engine or near it.
Replace all the parts in the case and store it in a safe place away from humidity and
out of the reach of children.
Ref.
1
2
3
4
5 Self-adjusting bits for anti-theft bolts
6
7
8 Impact socket Ø 24 mm

IMPORTANT

1) Do not use blades A(Ref.6) and B(Ref.7) when working on hardened anti-theft
bolts with special heads.
2) When working on hardened anti-theft bolts with special heads, use disposable bits;
otherwise, the blades would get damaged.
3) In order not to risk damaging the rim, some tape should be applied outside the
blade holder terminal.
Bolt removal by means of blades A and B
In order to check whether blades A and B can be used, test the bolt for hardness by
means of the centre punch contained in the kit. If the tip marks the bolt head without
showing any deformation or chamfering, the blades can be used; otherwise, they
cannot be used, as they would get damaged without producing any results.
Blade A installation example
Parts description
Impact socket holder
Centre punch
Hand protection ring
Blade holder
Blade A
Blade B
N°.of
pcs
1
1
1
1
3
1
1
1
Fig. 1