Publicidad
Idiomas disponibles
Idiomas disponibles
3. Welding process
A. Heating: apply a slight pressure both to the
tube and the accessory to let the adapters
go into the corresponding tube or accessory
(tube
to
female
male adapter) for the time stated in table.
B. Assembly:
Remove
accessory from their adapters and introduce
one into the other (NO TURNING) up to
the weld depth mark. This operation must
be done as fast and carefully as possible.
C. Setting and cooling: the time for this last stage
is shown in the table. Make sure no forces are
exerted onto the welding area during this time.
When the time is over, the welded tubes and
the accessories may be used following tube
manufacturer recommendations.
D. When you have finished, press the ON/OFF
key
so that the appliance goes into
3.5
standby. The appliance will start to cool down
immediately. Disconnect the appliance from
the mains when it is cold (<40ºC).
PRECAUTION
This product has not been tested for intensive use.
In case of continuous use for extended periods, let it
rest between uses
4. Checking the weld
The welding lip must be uniform all around.
Welding table for P.P. tubes
Plate temperature: 260ºC (temperature generally recommended by PPR manufacturers).
TUBE
Diameter mm. Thickness mm.
16
20
25
32
40
50
63
75
90
110
adapter,
accessory
the
tube
and
HEATING
Time sec.
2
5
2,5
5
2,7
7
3
8
3,7
12
4,6
18
3,6
24
4,6
28
6
34
7,5
38
Storage
PRECAUTION
When the equipment is no longer going to be used,
to
you are recommended to turn it off and allow it to
cool in order to store it
the
Store carefully in a safe, dry place out of the reach
of children.
Care and maintenance
If residues of material from previous welding
operations remain on the surface of the dies and
plate, carefully remove them.
PRECAUTION
Do not use metallic items or solvents to remove
residues, as these could damage the surface of the
adapter.
NOTE
Check the condition of the adapters from time to
time, to ensure correct welding.
Environmental protection and disposal
Equipment (WEEE).
ASSEMBLY
Max. time sec.
4
4
4
6
6
6
8
8
8
8
ENGLISH
This symbol means that if you wish to
dispose of the product at the end of its
service life, you must dispose of it by
appropriate means
with a waste manager authorised for the
separate collection of
Waste
Electrical
SETTING AND COOLING
Fixed tubes
sec.
5
5
7
8
12
18
24
28
34
38
and
Electronic
Free tubes
min
2
2
2
4
4
4
6
6
6
6
13
Publicidad
