GB
The
mark affixed to the product certifies that this latter complies with the
basic safety requirements.
I
Il marchio
applicato al prodotto certifica che il prodotto stesso soddisfa i
requisiti base di sicurezza.
F
La marque
apposée sur le produit certifie que le produit est conforme
aux règlements de sécurité.
D
Die
- Kennzeichnung, mit der das Produkt versehen ist, bescheinigt, dass es den
grundlegenden Sicherheitsanforderungen gerecht wird.
E
El marcado
aplicado al producto certifica que el mismo satisface los
aplicado al producto certifica que el mismo satisface los
GB
Your attention is drawn to the following actions that could compromise the certified characteristics of the product:
R
ead and keep the following the instructions
F
ollow all indications and instructions given on the printer
M
ake sure that the surface on which the printer rests is stable. If it is not, the printer could fall, and be seriously damaged;
M
ake sure that the printer rests on a hard surface and that there is sufficient ventilation;
When positioning the printer, make sure its cables will not be damaged;
Use the type of electrical power supply indicated on the printer label. If uncertain, contact your dealer;
Make sure the electrical system that supplies power to the printer is equipped with a ground wire and is protected by a differential switch;
If power is supplied to the printer using an extension cord, make sure that the total electrical input of the connected devices does not
exceed the maximum current permitted by the type of extension in use;
Do not block the ventilation openings;
Do not insert objects inside the printer as this could cause short-circuiting or damage components that could impair the printer operation ;
Do not carry out repairs on the machine yourself, except for the normal maintenance operations described in the user manual;
Make sure that there is an easily-accessible outlet with a capacity of no less than 15A in the place where the printer is to be installed;
Periodically perform scheduled maintenance on the printer so as to prevent dirt from building up and preventing it from functioning
correctly.
If a serial cable is used, it is better to install a ferrite at the end of it.
All manuals and user guides at all-guides.com
;
;
��
STB80