Problem Solving - GBC eWire Pro Manual De Instrucciones De Operación

9. PROBLEM SOLVING

A. Common Problems:
Problem Probable Cause
Power cord not attached to back of machine or
No power, No
not properly plugged into the wall.
Operation
Power On/Off Switch not activated
Close Ensure that the doors and cover are properly
Door/Close closed and latched. Press the door or cover
Tray/Close firmly into place. If message appears repeatedly,
Cover message adjust the Interlock flag.
appears
Twin-Loop wire Avoid damage to the spool by taking care during
jamming storage and loading.
repeatedly
Remove the excess wire and re-feed wire into
the element feed module. Follow the installation
instructions in Section 4.
If necessary, remove a length of wire from the
spool and reinstall the spool.
Confirm that an appropriate eWire™ Pro die is
Sheets jamming
repeatedly on installed on the MFPP. Using an unbound sheet,
the Stacking confirm the punched hole accuracy using the
area (Area 2) guidelines in Section 9 C-D. If the accuracy of
the punched holes is not in spec, make
J202, J203, J244
adjustments to the MFPP alignment settings. If
problem persists, see Section 9 E
J361 jams on the eWire™ Pro may be caused
Wire jamming in
feeder. (Area 3A) by dust on the film cover on the element sensor
(S22). Clean the film by wiping a dry cloth across
J361
the film covering the element sensor shown
below.
J361 jams can also be caused by the wire end
being positioned incorrectly when installing a
spool. Refer to Section 7 B step 16.
Broken carrier If the carrier paper between the wire spool and
paper rewind spool breaks, empty the rewind spool of
carrier paper and reattach the loose end from the
spool to the rewind spool hub, then follow the
spool installation steps starting on step 12. You
may need to cut off the excess wire if there is too
much slack in it.
Broken carrier Alternatively, you can repair the carrier paper
paper after emptying the rewind spool hub. Using a
discarded length of carrier paper, secure one
end to the rewind spool and cut it to length so
that there is enough for 2 inches (50mm) of
overlap with the paper end still attached to the
spool. Wrap the overlapped section in packaging
tape or secure with 3 staples then follow the
spool installation steps starting on step 12.
Broken carrier
paper
(continued)
J320 jams on the eWire™ Pro may be caused
Wire failing to
trigger slack by the carrier paper between the wire spool and
sensor. (Area rewind spool breaking or by becoming entangled
3A) on the wire. Refer to Section 7 B steps 1-5 and
steps 11-19 For reinstalling the spool. Note: It
J320
may be necessary to trim off excess wire if the
length of carrier paper is not sufficient to reach
the rewind spool or if the wire has been
damaged by stretching.
J320 jams on the eWire™ Pro may also be
caused by debris collecting on the element slack
sensor and restricting its motion. Clear the
debris with a cloth or vacuum. Compressed air
can be used to clear the area under the flapper
as well.
Full Rewind J320 jams can occur when the rewind spool
Spool becomes too full. The rewind spool has a
window cut into it. When paper reaches this
J320
window, cut the paper where it leave the rewind
spool and perform steps 16-17 in Section 7 A to
empty the hub and then reattach the cut end to
the now empty spool
Poor closing or Poor closing and stacking can occur for A5 and
stacking with A5 statement size books if the book drawer bar not
14
eWire™ Pro
GB