Ewire™ Pro Dies For Mfpp-B1; Quick Start Guide; User Operations - GBC eWire Pro Manual De Instrucciones De Operación

5. EWIRE™ PRO DIES
Prior to Operation of the eWire™ Pro, an eWire™ Pro die set must
be installed into the Multi Function Professional Puncher-B1.
eWire™ Pro will not function unless one of the die sets listed below
is installed.
Die Set Details
A die set from the following list must be used. Refer to Section 10 of this
document for further details.
Die, eWire, 3:1, Round
Die, eWire, 3:1, Square
Punched Hole Quality
Prior to operating the eWire™ Pro for the first time, or whenever a die
set is changed, perform the hole quality check outlined in Section 9 B.

6. QUICK START GUIDE

eWire™ Pro must be connected to AC power and the rear ON/OFF
switch should be ON to enable any feature of the machine.
 A spool of the correct size twin loop wire must be installed before
running a bind job. See Section 7 B for details on loading twin
loop spools into the eWire™ Pro
 Ensure that the book drawer in Area 4 is set to the size paper
you intend to use, shown below.
 If running A5 or Statement size jobs, install the book drawer
bar. To install the book drawer bar, place the drawer guides in
the narrowest postion and then slide the bar underneath the
guides until the indicators touch the edge, shown below.
7714030
7714031
 Check that the Multi Function Professional Puncher-B1 has an
eWire™ Pro die as detailed in Section 5.
 Do not open doors while the machine is operating. The current
job will not resume if any eWire™ Pro doors are opened while
"RUNNING BINDING" OR "PAUSED" is displayed on the LCD.
When binding is not directed the machine will operate in bypass mode.
DOWN
Layout of eWire™ Pro LCD User Interface

7. USER OPERATIONS

A. Removing Supply Spool from the Machine:
Supply spools can be removed from the machine before they are
empty to be stored for future use.
B. Installing a New Supply Spool into the Machine:
eWire™ Pro offers a variety of different twin loop wire options,
depending on the requirements of your job. Load a new wire supply
spool if a different size or color of binding is required, or when the
spool is empty.
C. Supply Spool Storage:
The twin loop wire supply spools should always be stored
according to the guidelines listed to prevent damage.
D. Emptying the Book Drawer:
Empty the book drawer to remove your bound books.
E. Clearing Jams:
How to clear paper or wire jams.
6
eWire™ Pro
GB
UP
OK