Displayed Messages; Cleaning And Maintenance - Steinberg Systems SBS-CS-3000 Manual De Instrucciones

3. Press the "UNIT" button to confirm the selection.
CAUTION: The auto shut-off function will not work when a power supply is
connected to the unit.
3.3.5. TIMER:
1. Press the
Press the same button again to finish and then hold to clear the result.
2. "000" will appear on the display. Then hold down the "UNIT" button until the
display shows "3'00".
3. Press the "UNIT" button again to select the time to count down from 3 to 8
minutes.
4. Confirm by pressing the "START/STOP" button. The countdown will start. Press
the same button to stop.
5. Hold down the "START/STOP" button to turn off the timer function.
3.3.6.

DISPLAYED MESSAGES:

"Err 1": overload
"LO": batteries low
"PRSS": calibration was successful
3.3.7. CALIBRATION:
1. Turn on the scale.
2. Hold down the "UNIT" button until the display indicates "200g".
3. Press the "TARE" button to select a calibration value from 200/500/1000/2000
g.
4. Press the "UNIT" button to confirm the selection. The display will show "CAL".
5. Place an object with the displayed (selected) weight on the scale.
6. Wait until the display shows "PASS", indicating a successful calibration.
7. Press the ON/OFF button if there is a problem and try again.
If calibration is successful, press the same button to return to normal operation.

3.4. Cleaning and maintenance

a) Store the unit in a dry and cool place protected from moisture and direct
sunlight.
b) Do not spray the unit with a stream of water or immerse it in water.
"START/STOP" button to start the timer.