Working With The Unit - MSW Motor Technics MSW-TCT-01 Manual De Instrucciones

MOUNTING THE UNIT (see picture below)
a) Using the brackets, connect the rim to the base using 4 M6 screws with washers
and nuts.
b) Attach the separator lever rod to the base using 3 socket head screws.
c) Attach the rim mounting rod to the separator lever rod to the base using the
nuts at the top and bottom of the rod.
d) Place the separator on the lever rod.
e) Connect the separator lever together with the rod attached to the chassis.
f) Place each of the four rim protectors on the rim where they connect to the
brackets.
3.3.

Working with the unit

A. Place the tool on a stable, flat, paved surface.
B. Let the air out of the wheel completely.
C. Loosen the wing nut of the wheel mounting rod.
D. Lay the wheel (rim with tire on it) horizontally on the rim so that the
mounting rod passes through the centering hole in the rim.
E. Tighten the wing nut of the mounting rod so that the rim does not fall off
the rim and can be freely rotated on the rim.