Bosch rexroth 3 842 998 350 Manual De Instrucciones página 90

12/78 Safety instructions
During start-up
During operation
During maintenance and
servicing
During disposal
Bosch Rexroth AG, MPS: HEAP, 3 842 555 612/2019-01
• Allow the product to acclimatize for a few hours prior to start-up in order to
prevent water condensation from forming in the housing.
• Make sure that all electrical and pneumatic connections are either in use or
covered.
• Check the safety distances in accordance with DIN EN 349 or other regulations
for the respective application (acceptance by an electrical technician taking into
account country-specific requirements for the respective application).
• Only start up a product that has been completely installed.
• Make sure that all the safety equipment which forms part of the product is present,
has been properly installed, and is fully functional. Do not move, bypass or disable
any safety equipment.
• Do not reach into moving parts. Note possible stroboscopic effects, that is, parts
that only seem to be stationary.
• Check the product for malfunctions.
• Make sure that only authorized personnel perform the following tasks as part of
the intended use of the product
– Starting or operating the system, or interfering with its normal operation.
– Operating component or part adjusters.
• Only allow people to be in the immediate vicinity of the product when it is
operating if they are authorized by the operator to be there. This also applies while
the product is not in motion.
• Do not reach into moving parts. Note possible stroboscopic effects, that is, parts
that only seem to be stationary.
• An idle system is not necessarily a safe system, as stored energy can be released
unintentionally or through improper maintenance procedures.
• Do not reach into moving parts.
• Make sure that access to maintenance and inspection points is kept unobstructed.
• Perform the prescribed maintenance work at the intervals prescribed in chapter
10.2 on service.
• Make sure that no line connectors, connections or components are disconnected
as long as the system is supplied with pressure and voltage. Secure the system
against being switched back on.
• Dispose of the product in accordance with the regulations in your country.