Attach Dacor Badge - Dacor DHDU990I/DA Serie Instrucciones Para Instalación

Installation

Attach Dacor badge

Use the template on this page for alignment of the badge.
Cut out the template and tape it onto the hood front
surace and verify the template is aligned with the right
side of the hood and within the upper and lower edge of
the front surface. Practice placing the badge first before
removing the adhesive release paper.
Dacor
Badge
Template
Duct cover
Bottom edge of
the duct cover
NOTE: The nameplate badge has very high retention adhesive - once the nameplate badge is attached its extremely difficult to remove.
Before removing the release paper from the back of the nameplate badge, practice placing the nameplate badge in the proper position on the hood
without any overlap between the nameplate badge and this template.
After this practice, remove the release pper from the back of the nameplate badge, and attach the nameplate badge to the hood without any overlap
of the nameplate badge to this template.
Remove and discard this template.
23