Lindy 70445 Manual Del Usuario página 3

User Manual
Product Diagram
Front Panel
3.5mm – Push to select the 3.5mm Input or Output.
Opt – Push to select the TosLink (Optical) Input or Output.
Bluetooth – Push and hold to enable pairing mode. Please see below for further information.
Rear Panel
5V – Connect the USB Micro-B cable from a USB PSU or source.
3.5mm Audio Out – Connect to a 3.5mm Audio Output using a 3.5mm Male to Male cable.
TosLink (Optical) Audio Out – Connect to a TosLink (Optical) Audio Output using an optical cable
3.5mm Audio In - Connect to a 3.5mm Audio source using a 3.5mm Male to Male cable.
TosLink (Optical) Audio In – Connect to a TosLink (Optical) Audio source using an optical cable
TX – Push switch to activate Transmitter mode.
RX – Push switch to activate receiver mode.
Off – Push switch to turn off transceiver.
Installation & Operation
Using double-sided sticky pad, mount the transceiver in a location that has no obvious obstructions that
may interrupt the Bluetooth signal.
Connect the USB Micro-B cable to the transceiver, with the USB Type A side connected to a USB power
supply or port.
Using the rear panel switch, select which functionality is required, whether Transmitter or Receiver. The
LED will flash to indicate the Transceiver is powered on. To switch the transceiver off, push the switch to
"Off".
LED Indicator
LED Indicator Off – Power Off

Illuminated Blue with Slow Pulse – Power on with TosLink (Optical) Connection Selected

Illuminated Green with Slow Pulse – Power on with 3.5mm Connection Selected

Flashing Blue and Red – Pairing with a TosLink (Optical) Connection

Flashing Green and Red – Pairing with a 3.5mm Connection

Solid Blue – Successfully paired with a TosLink (Optical) Connection

Solid Green – Successfully paired with a 3.5mm Connection

English