Set The Basic Settings - JVC KD-X480BHS Manual De Instrucciones

Getting Started
To set the date
7
Turn the volume knob to select [DATE SET], then press the knob.
8
Turn the volume knob to make the settings, then press the knob.
Set the date in the order of "Day" "Month" "Year".
9
Press to exit.
To return to the previous setting item, press
3

Set the basic settings

1
Press and hold .
2
Turn the volume knob to select an item (see the following table), then
press the knob.
3 Repeat step 2 until the desired item is selected or activated.
4 Press to exit.
To return to the previous setting item, press
[SYSTEM]
[KEY BEEP] (Not applicable when 3-way crossover is selected.) (Page 29)
[ON]: Activates the keypress tone. ; [OFF]: Deactivates.
[SOURCE SELECT]
[AM SRC]*1 [ON]: Enables AM in source selection. ; [OFF]: Disables.
(Page 7, 9)
[BT AUDIO SRC]*1 [ON]: Enables BT AUDIO in source selection. ; [OFF]: Disables.
(Page 24)
[BUILT-IN AUX]*1 [ON]: Enables AUX in source selection. ; [OFF]: Disables. (Page 13)
6
ENGLISH
[F/W UPDATE]
[UPDATE SYSTEM]*2/[UPDATE HD]*3
.
[FACTORY RESET]
[CLOCK]
[TIME SYNC]
[CLOCK DISPLAY]
.
[ENGLISH]
Default: [XX]
[ESPANOL]
[FRANCAIS]
[DEMO MODE]
*1 Not displayed when the corresponding source is selected.
*2 Firmware downgrade is prohibited.
*3 Only for KD-X480BHS.
[F/W UP xxxx]/ [YES]: Starts upgrading the firmware. ; [NO]: Cancels (upgrading is not
[F/W UP Vxx]*3 activated).
For details on how to update the firmware, visit
<https://www.jvc.net/cs/car/>.
[YES]: Resets the settings to default (except the stored station). ;
[NO]: Cancels.
[ON]: The clock time is automatically set using the Clock Time (CT) data in
FM Radio Broadcast Data System signal. ; [OFF]: Cancels.
[ON]: The clock time is shown on the display even when the unit is turned
off. ; [OFF]: Cancels.
Select the display language for menu and music information if applicable.
By default, [ENGLISH] is selected.
[ON]: Activates the display demonstration automatically if no operation is
done for about 15 seconds. ; [OFF]: Deactivates.