Connecting Cables To Terminals - Kenwood KTC-9090DAB Manual De Instrucciones

Connecting Cables to Terminals

2CAUTION
DC voltage is output from the DAB
antenna terminal of the DAB
hideaway tuner to supply power to
the DAB antenna. Be sure to connect
the supplied DAB antenna only.
Otherwise, the unit may be
damaged.
DAB connection
cable
(Accessory1)
HEAD
To control unit
Connection cable
(supplied with the
Disc changer)
Disc changer
■ If you want to connect KCA-S210A
Control unit
26
Downloaded from:
DAB HIDEAWAY TUNER
K T C – 9 0 9 0 D A B
24bit D.R.I.V.E.
TO RDI
TO
CHANGER OUTPUT DAB
UNIT
]"N"
O N OFF ON
PROTOCOL AUX
AUX
SWITCH SWITCH
IN
TO TO TO
H/U CHANGER 1 CHANGER 2
KCA-S210A
http://www.usersmanualguide.com/
To KENWOOD disc changer / DAB control input
Control unit
Power control/Motor
antenna control wire
(Blue/White)
DAB hideaway
tuner
1
TO
ANTENNA
2
3
DAB antenna cable
(Accessory@)
RDI output
NOTE
• To use the data output from the Radio Data
Interface (RDI) connector, a separate RDI-enabled
component is required.
• The Radio Data Interface (RDI) output may contain
test data, but this isn't broadcast data.
KENWOOD disc changer control input
NOTE
To connect the Disc changer, consult your Disc
changer manual.
DAB hideaway tuner
TO TO
HEAD UNIT CHANGER
Disc changer
(*...commercially available)
FM/AM antenna input
P.CONT.
ANT.CONT.
FM/AM antenna cable*
FM/AM antenna
control cable*
(M10)
DAB/FM/AM
antenna
(Accessory7, 8)
Connect the KTC-9090DAB to the
terminal labelled TO CHANGER 2.
NOTE
Set the PROTOCOL selection
switch to "N" position.