Replace The Blade; Store The Machine; Fold Away The Handle; Troubleshooting - GreenWorks Powerall LME476 Manual Del Operador

EN
9.2

REPLACE THE BLADE

20
Use only approved replacement blades.
Wear heavy gloves or wind cloth around the blade when
you touch the blade.
1. Stop the machine.
2. Make sure that the blade fully stops.
3. Remove the safety key.
4. Remove the battery pack.
5. Turn the machine to its side.
6. Use a piece of wood to prevent the movement of the
blade.
7. Remove the mounting bolt (18) and spacer (19) with a
wrench or socket.
8. Remove the blade (20).
9. Install the new blade. Make sure the arrows on the fan
engage the holes on the blade.
10. Put in the mounting bolt and spacer and tighten them.
10

STORE THE MACHINE

• Remove the safety key.
• Remove the battery pack(s).
• Clean the machine before storage.
• Make sure the motor is not hot when you store the
machine.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, follow these
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person at an approved service center.
• Store the machine in a dry area.
• Make sure that children cannot come near the machine.
English (Original Instructions)
19
18
WARNING
WARNING
11

FOLD AWAY THE HANDLE

7
10
1. Loosen the lower handle knobs (10) at both sides;
2. Push inward the lower handle ends to break free from the
brackets;
3. Fold down the handle for storage. Make sure the lower
handle holes engage with the lock pins (7)
12

TROUBLESHOOTING

Problem Possible cause
The handle is not The handle fasten-
in position. ers are not engag-
ed correctly.
The machine does The battery ca-
not start. pacity is low.
The bail switch is
defective.
The battery key is
not put in.
The machine cuts The lawn is rough. Examine the mow-
grass unevenly.
The blade height is
not set correctly.
The machine is The grass is too
hard to push. tall, or the blade
height is too low.
12
Solution
Adjust the height
of the handle and
make sure that the
fasteners are prop-
erly positioned.
Charge the battery
pack.
Replace the bail
switch.
Put in the battery
key.
ing area.
Move the wheels
to a higher posi-
tion.
Increase the blade
height.