Descargar Imprimir esta página

Attaching The Fan Blades - AirPro Progress Lighting P250076 Manual De Instalación

Publicidad

Idiomas disponibles

Idiomas disponibles

Finishing the Fan
Installation
STANDARD CEILING MOUNTING
WHEN USING THE STANDARD BALL/DOWNROD
MOUNTING, THE TAB IN THE RING AT THE
BOTTOM OF THE MOUNTING PLATE MUST
REST IN THE GROOVE OF THE HANGER BALL.
FAILURE TO PROPERLY SEAT THE TAB IN THE
GROOVE COULD CAUSE DAMAGE TO WIRING.
1. Align the locking slots of the ceiling canopy with
the two screws in the mounting plate. Push up
to engage the slots and turn clockwise to lock
in place. Immediately tighten the two mounting
screws firmly.
2. Install the remaining two mounting screws into
the holes in the canopy and tighten firmly.
3. Install the decorative canopy ring by aligning the
ring's slots with the screws in the canopy. Rotate
the ring counterclockwise to lock in place.
4. You may now proceed to attaching the fan blades.
7.
Attaching the Fan
Blades
1. Attach the blade to the the fan motor assembly,
align the screw holes in the blade with the screw
holes above and under the motor assembly and
secure screws. (Figure 12)
2. Repeat this step for the remaining the blades.
Figure 11
Blade Balancing
All blades are grouped by weight. Because natural
woods vary in density, the fan may wobble even
though the blades are weight matched.
The following procedure should correct most fan
wobble. Check after each step.
1. Check that all blade screws are secure.
2. Most fan wobble problems are caused when blade
levels are unequal. Check this level by selecting
a point on the ceiling above the tip of one of the
blades. Measure from a point on the center of
each blade to the point on the ceiling. Measure
this distance as shown in Figure 12. Rotate the fan
until the next blade is positioned for measurement.
Repeat for each blade. Measurements deviation
should be within 1/8". Run the fan for 10 minutes.
3. Make sure that canopy is tightened securely to
ceiling mounting bracket and that the ceiling
mounting bracket is tightened securely to the
electrical box.
4. Interchanging two adjacent blades can redistribute
the weight and possibly result in the smoother
operation.
5. Use the enclosed Blade Balancing Kit if the blade
Figure 12
wobble is still noticeable.
Figure 13

Publicidad

Solución de problemas

loading